Need metal roof installation in Los Angeles? We come look first, tell you plainly what it needs, and put the price in writing before anything starts.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Los Angeles install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Our metal roof installation work in Los Angeles is handled by crews who do this every week, not by whoever happened to be free that morning. It shows up in the details — valleys, chimney flashing, eave and ridge closures — because that is where roofs actually leak.
We schedule your Los Angeles metal roof installation for a stretch of dry weather, keep the job site picked up as we go, and do not leave a roof open overnight. When it is done the tear off is hauled away and a magnet goes over the drive.
Four steps and no surprises. This is how we have done it since 2002.
We measure the roof on site, count the valleys, hips and penetrations, and bring the color chart so you can hold it up against your siding.
Where the decking is sound and there is only one layer, we can often go over the top on purlins. We tell you which one your house calls for.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Ridge caps, closures, drip edge and gable trim finish the roof and keep wind driven rain and wasps out from under the panels.
What comes up on just about every estimate for a job like this.
Much less than people expect. Over solid decking with underlayment, a Los Angeles metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Los Angeles homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Installed properly over sound decking, a metal roof should give a Los Angeles home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
Most Los Angeles metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Real feedback from homeowners we have worked for.
"Old slate roof and I was afraid nobody would touch it. They matched the pieces and now you cannot tell which ones are new."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Cannot say enough about how careful they were around the flower beds. Everything got covered and nothing was trampled."